安信可 softAP静态IP示例

---

Wi-Fi SoftAP custom IP Setting Example

Introduction

This example shows how to use the Wi-Fi Station functionality of the Wi-Fi driver of WB2 serial development board and set custom IP address.

How to use example

Open the project,set AP_SSID,AP_PASSWORD and custom IP address at line 3,line 4 and line 7. For example :

#define AP_SSID "Ai-WB2"
#define AP_PASSWORD "12345678"
#define AP_IP "192.168.100.1"

Finally,running command below to compile project on ubuntu.

make -j8

Burn firmware

Running command below to burn firmware after connecting WB2 serial development board to ubuntu.

make flash p=/dev/ttyUSB0 b=921600

Debug

Open the serial port debugging assistant software,select the COM port of the development board,and press the reset button on development board to run the program finally.

Troubleshooting

For any technical queries, please open an [issue](https://github.com/Ai-Thinker-Open/Ai-Thinker-WB2/issues) on GitHub. We will get back to you soon.

简介

本例程主要介绍如何实现WB2系列开发板AP模式下设置自定义IP。

如何使用该例程

打开项目，在第3、4以及第7行设置AP_SSID、AP_PASSWORD以及自定义IP地址 如下：

#define AP_SSID "Ai-WB2"
#define AP_PASSWORD "12345678"
#define AP_IP "192.168.100.1"

最后，在ubuntu下运行以下指令编译工程。

make -j8

烧录固件

将WB2开发板连接ubuntu之后，运行以下指令烧录固件。

make flash p=/dev/ttyUSB0 b=921600

调试

打开“串口调试助手软件”，选择并打开开发板的COM口，最后按下复位键启动程序。

问题排除

若有任何问题，请在github中提交一个[issue](https://github.com/Ai-Thinker-Open/Ai-Thinker-WB2/issues)，我们会尽快回复。